LITTLE BOY
 

The doll is going from separate elements.
For making the doll's head, use a 10 cm (4-inch) square of paper.
For making the doll's body, use a rectangle of paper, 10x20 cm (4x8 inch) in size.
For making the doll's hands, use a rectangle of paper, 5x20 cm (2x8 inch) in size.
You will also need a tube of paper glue.

THE HEAD
Use a 10 cm (4-inch) square of paper.
1 Valley fold the sheet in half from top to bottom. Press the paper flat.
2 Valley fold the paper in half from side to side. Press it flat and unfold it.
3 Valley fold the left-hand side over to meet the vertical middle fold-line. Repeat the same with the right-hand side.
4 Open out the layer and move it in the direction shown by the arrow.
5 Repeat the previous step for the left-hand side.
6 This should be the result. Turn the model over.
7 Lift up the front layer as far as it will go.
8 Mountain fold the corners back as shown. Turn the model over.
9 Valley fold the corners, thereby making the baby's ears.
10 Valley fold the corners as shown.
11 This should be the result. Turn the model over.
12 Form the panama's edges by outside reverse folding a little.
13 Form the ear's shape.
14 Draw a cheerful face - and the head of the paper doll is ready.

THE BODY
Use a rectangle of paper, 10x20 cm (4x8 inch) in size.
1 Valley fold the sheet in half from top to bottom. Press the paper flat.
2 Valley fold the paper in half from top to bottom. Press it flat and unfold it.
3 Valley fold the paper in half from side to side. Press it flat.
4 Valley fold the double layer in half over to meet the left-hand edge.

 wpe1.jpg (158884 bytes) 5 Move the top left-hand corner of the front flap in the direction shown by the arrow, at the same time form a step fold in the middle of the front flap.
6 This should be the result. Turn the model over.
7 Valley fold the double layer in half over to meet the right-hand edge.
8 Move the top right-hand corner of the front flap in the direction shown by the arrow, at the same time form a step fold in the middle of the front flap.
9 This should be the result. Move the bottom layers apart a little bit, that the baby's body was steady. Here is the completed body for the paper doll!

THE HANDS
Use a rectangle of paper, 5x20 cm (2x8 inch) in size.
1 Valley fold the paper in half from bottom to top. Press it flat and unfold it.
2 Valley fold the top and bottom edges over to meet the middle fold-line.
3 Valley fold the paper in half and unfold it.
4 Valley fold the sides over to meet the middle fold-line and unfold them.
5 Valley fold the left-hand side over to meet the fold-line made in the previous step and unfold it. Repeat the same for the right-hand side.
6 Step fold the ends, using the fold-lines made in the previous steps as shown.
On the following diagrams one half of hands will be shown only because other half develops similarly.
7 Valley fold the corners and unfold them.
8 Open out the "pockets" and squash them neatly.
9 Valley fold the corners as shown.
10 Turn the paper over. Valley fold the front layer as far as it will go.
11 Repeat the previous steps for other side of the paper strip, thereby making other hand... And the hands for the paper doll are ready.

ASSEMBLY
Open out the body, then put the hands as shown (it is possible to glue it) and close it. Glue the head to the body.
The cheerful paper boy is ready!

İnsanlar Sayfasına Dön

Ana Sayfaya Dön