|
|
| UNICORN |
1. Fold and unfold the paper in half along one diagonal, then fold and leave folded along the other diagonal.
2. Fold the corners inward.
3. Enlarged view. rotate the model 90 degrees counter-clockwise.
4. Fold and unfold in both directions. Turn the model over.
5. Fold and unfold. turn the model over.
6. Carefully fold a preliminry base on the existing creases.
7. Petal fold all the layers upward and fold the flap back down. Repeat behind.
8. Unfold the model to step 6.
9. Fold the two points to the left.
10. Fold the point downward following the existing creases.
11. Rabbit ear the flap to the right.
12. Repeat steps 10 - 11 on the bottom flap.
13. Fold the model in half.
14. Fold the flaps to the left.
15. Inside reverse fold the point.
16. The purpose of the next three steps is to execute a wrap on points A & B. Unfold the model to step 13.
17. Open the model partially.
18. Reverse the direction of points A and B, then fold the model back up, following the existing creases, to a position similar to step 16.
19. Rabbit ear the front leg. Repeat behind.
20. Reverse fold the hidden points.
21. Fold the flap in half. Repeat behind.
22. Fold the back of the leg in half in the opposite directin. Repeat behind.
23. Pull one thickness to the right. Repeat behind.
24. Watch carefully. Reverse fold the back leg asymetrically, repeat behind.
25. Reverse fold the back leg asymetrically again in the opposite direction. Repeat behind.
26. Thin the back of the leg by one fourth, repeat behind.
27. Reverse fold the tail upward.
28. Reverse fold again.
29. Reverse fold asymetricaly. Repeat behind.
30. Crimp fold the tail while simultaneously pushing half of the middle of the tail inside out.
31. Fold and unfold the flap not quite halfway. Repeat behind.
32. Sink the two areas triangularly.
33. Reverse fold. Note that the crease does not go point to point.
34. Outside reverse fold.
35. Pull out two small hidden flaps.
36. Outside reverse fold the horn from the center of the head. Be very creful, it is easy to tear off the horn at this point. You may need to use a paper clip or tweezers.
37. Thin the horn further by sinking it in half.
38. Crimp fold the ear. Repeat behind.
39. Complete the ear by flding the flap back to form a point. Repeat behind.
40. Outside reverse fold the tip of the nose.
41 Reverse fold the nose again.
42. To complete the model, press the body and horn to make them 3D.
